Facebook Twitter YouTube RSS
magnify
Home Posts tagged "DIY edrums" (Page 6)

Trigger Without A Piezo!

There has been some talk over on Vdrums.com & eDrumming.com about triggering an electronic drum module with a DC voltage. The I have achieved this, and the video below shows how. I also included a schematic of how this test could be expanded. I have not tried this with an Alesis or a Roland drum

Read More…

 
 Share on Facebook Share on Twitter Share on Reddit Share on LinkedIn
2 Comments  comments 

Get a Choke Hold (eCymbal Choke Switch)

I have had this idea for awhile now, but I am just getting around to do something about it. What I have here is what I hope will become the standard DIY eCymbal choke design. It’s simple, low profile, and easy to build. It is in essence a film switch. As time goes on, I

Read More…

 
 Share on Facebook Share on Twitter Share on Reddit Share on LinkedIn
9 Comments  comments 

More Detail about Set #5

If you go to the gallery page, you see most of my past attempts at trying to prefect what I thought would be the be perfect eDrum set. Set numbers 4a, 4b, & 5 use an aluminum shell hoop that I rolled myself. I knew when I did these that there were few, if any,

Read More…

 
 Share on Facebook Share on Twitter Share on Reddit Share on LinkedIn
No Comments  comments 

Painting the Bases & adding T-nuts

The first thing that we need to do is disassemble the mounting plates and eye-bolt assembly. Once that is done we can start to paint. I would suggest that we paint outside so it is well ventilated. Hang the base on a string or wire and spray paint on a gray primer (unfortunately the super

Read More…

 
 Share on Facebook Share on Twitter Share on Reddit Share on LinkedIn
1 Comment  comments 

Aluminum Plates & Getting it Together

We need to reinforce the mounting area of the base. Not only that, but we need to cover the eyebolt and give the L-rod something to push against.

 
 Share on Facebook Share on Twitter Share on Reddit Share on LinkedIn
No Comments  comments